GeNetix Firmware Release Notes

Fix for issue when using sequential IP addresses with multiple nodes that included GN5, GN10, GN10P and GN10R devices.

Fix for updating the IP address when loading a User Config.

Add "Playback Only" mode to the web server Scenes view.

Fix for applying User Configs via the web server after configuring from a Quick Setup option.

Fix for correctly toggling Scene 10 via the web server. Previously the Scene would activate but report an error.

Add support for GeNetix GN8.

Add support for GeNetix GN10P and GN10R.

Web server improvements, adding 10Scene configuration, port merging, and timecode control.

Fix for RDM discovery when ports are set to sACN.

Fix for reporting of Universes above 4095 in Art-Net Poll Reply.

Fix for network output memory leak introduced in V2.10 that would cause the network output to stop after the device had been running for a few hours.

Fix issue where CREP scene 10 would not work for any states.

Add support for CREP state command 4 (toggle). (#0041878)

Fixes for missing MIDI messages.

Fix for LTC timecode to work with a larger gain range. (#0041701)

Fixed an issue with Identify mode when used with multiple devices.

Fix for possible issue with devices restarting after a long period of time.

Fix for some settings not resetting to factory default when done via MagicQ.

Fix for storing scene name and fade time via MagicQ Send Scenes.

Fix for removing an active scene via MagicQ.

Fix for last scene activation on device startup.

Improve message buffering for 10Scene messages.

Improvements to RDM discovery time.

Fix for sACN priority handling when the same value. (#0042210)

Fixes for sACN multicasting.

Improvements to Web server features.

Implemented detection of multiple data sources on a single port, the affected port on the GeNetix product will turn red (Home Screen and Port LED).

Add support for Merging (HTP, LTP, Highest IP and Lowest IP options) this can be configured in the net manager ports menu.

Added in menu option for Timecode input port selection.

Add support for Identify to work when the device is PIN locked.

Add a "Reset Configuration" option for resetting individual configurations.

Add support for a Lost Data mode of "Scenes Panel" feature where control can pass from the console to the GeNetix device.

Show Art-Net timecode on the GeNetix device when the Timecode input option is selected.

Add support for some characters that were not supported for naming, previously only . - _ < and > were supported in port names.

Added additional scene and panel enable/disable trigger mode options.

Added 10Scene external control support, 10Scene external control support includes the 10Scene App, MIDI Notes 0-9 and CREP (ChamSys Remote Ethernet Protocol).

Fix 10Scene Wall Plates not seen by MagicQ when connected via GN5 / GN10. (#0040464)

Fix 10Scene Wall Plates unable to set ID and ID ignored by GN5/10. (#0040465)

Fix 10Scene Wall Plate ID being ignored when connected to GN5/10. (#0040466)

Resolve issue with some GeNetix devices getting stuck in factory test mode.

Add support for GeNetix GN5 & GN10.

Initial release version.